|
|
|
|
|
|
|
|
|
| The
OZ 3000 has been designed
to measure Ozone in a room or area. The unit is designed to
be mounted in the area and measure the Ozone content in the
air. It can be used to measure the Ozone in the area where
an Ozone generator is used, or an Air Purifier is used to
purify the air in the room.
The unit is designed to measure Ozone from 0-100 ppb (parts
per billion). The unit has a relay output and a 4-20ma
output for control and alarming purposes. The OZ 3000 is housed
in an ABS plastic case for easy mounting and installation
in wide set of conditions. It is power by a 120 V power source
and supplies all the power for continuous operation. |
 |
|
|
|
|
|
$450.00 |
|
|
| Operation
The Monitor starts operation in 3 minutes after power on.
After that, the output is released every 250 ms.
NOTE: IF THE MONITOR IS STORED FOR A LONG PERIOD OF TIME
WITHOUT POWER, PLEASE CONTINUOUSLY SUPPLY DC FOR MORE THAN
4 DAYS BEFORE MONITOR WILL BE ACCURATE.
Specifications: |
|
|
|
|
|
|
|
|
| Sensor |
Semiconductor
Gas Sensor |
| Detection Gas |
Ozone (O3) |
| Detection
Range |
0-100 ppb |
| Response |
30 Seconds |
| Initial Warm Up Time |
10 Minutes |
| Relay Output |
Contact Closed at 100 ppb
Contact Rating – 24VDC, 2A Maximum |
| Current Output |
4-20 ma (External Load Resistor 0-50 Ohms) |
| Normal Operating Temperature |
0-40 C (32 to 110 F) |
| Storage Temperature |
-10 to 60 C (14 to 140 F) |
| Power Supply Voltage |
120 VAC (DC Supply 8-15 VDC, 300 ma Minimum) |
| Protective Case |
ABS Plastic |
| Weight and Case Dimensions |
8 0z. Dimensions 6”L X 3.4” W X 1.5” H |
| |
|
|
|
|
|
Click
here to download Product Information PDF... |
|
|
| |
| Copyright © D&D Engineering.
All Rights Reserved.
|
|
s
